7580006中文資料圖爾克數(shù)據(jù)手冊PDF規(guī)格書

Sensors according to EN 60947-5-6 (NAMUR)

or potential-free contacts can be connected

to the IMX12-DI03-1S-1NAM1T-0/24VDC/CC

NAMUR repeater. The device is equipped with

an intrinsically safe input circuit and can be installed in zone 2. The output circuit is additionally equipped with 1 transistor output. The device complies with the requirements of NE21.

The devices feature DIP switches on the front.

Thus, input circuit monitoring and the direction

of action can be switched separately. When

using mechanical contacts, either line monitoring must be switched off or the contact

must be wired with resistors (see wiring diagram).

The green LED indicates operational readiness. An error in the input circuit causes the

red LED to flash according to NE44. A LOW

level is then output at both outputs.

The device can be used in safety circuits up to

SIL2 (high and low demand according to IEC

61508).

The device is equipped with removable spring

type terminals.

■ Transistor output (e10 kHz)

■ NAMUR Repeater

■ Input circuits monitored for wire-break and

short-circuit

■ Complete galvanic isolation

■ Input reverse-polarity protected

■ Removable spring type terminals

■ ATEX, IECEx, NEPSI, cUL, cFM, INMETRO, KOSHA, TIIS, TR CU EAC,

■ Installation in zone 2

■ SIL 2