0900236電路保護的斷路器規格書PDF中文資料

0900236屬于電路保護的斷路器。由德國菲尼克斯電氣集團制造生產的0900236斷路器斷路器是一種自動操作的電氣開關，可用于保護電路免于因過載或短路引起的過流而受損?；竟δ苁窃跈z測到故障后中斷電流。與只能操作一次然后必須更換的保險絲不同，斷路器可以復位（手動或自動）以恢復正常操作。

Description

The ECP-E2… electronic circuit breaker can be used in

applications that cover all aspects of the switched-mode

power supply unit.

In the event of an overload, switched-mode power supply

units reduce their output voltage, which means that all the

connected loads are no longer sufficiently supplied, e.g., in

the event of a short circuit at the load.

The solution here is the ECP-E2… electronic circuit breaker,

which selectively protects all 24 V DC load circuits. The

ECP-E2… constantly limits the residual current to 1.8 times

(or 1.5/1.3 times) the protected nominal current. Capacitive

loads can thus be switched on and loads are only switched

off in the event of an overload or short circuit.

In addition, the ECP-E2… can be controlled remotely by

means of the control input (12), for example, via a PLC, i.e.,

the ECP-E2… is electronically connected by means of an

external +24 V DC permanent signal (at connection 12),

enabling current to flow in the load circuit. Defined

shutdown, independent of the load, is carried out by

applying the ground signal at the same control input (12).

The floating auxiliary contacts of the ECP-E2… can be used

to implement a group query from connection 13 to 14. If a

circuit breaker trips or is disabled, the signal to connection

14 is interrupted.

A multi-color LED and the signal contact indicate the

operating or error state.

Properties

– Selective load protection, electronic shutdown

characteristic curve

– Active current limitation when switching on capacitive

loads up to 20,000 μF and in the event of overload/short

circuit

– Nominal current can be selected in fixed current

strengths from 1 A ... 12 A

– Safe overload shutdown from 1.1 x IN, even for long

load cables or low cable cross-sections

– Manual on/off switch (S1)

– Control input IN+ for remote ON/OFF signal

– Indication by means of LED or signal contact F

– Integrated failsafe element

– Design width of just 12.5 mm per channel

– Can be plugged into a modular base