0912101中文資料圖爾克數(shù)據(jù)手冊PDF規(guī)格書

Sensors according to EN 60947-5-6 (NAMUR) or potential-free contacts can be connected to the IMX12-DI01-2S-2T-PR/24VDC/

CC isolating switching amplifier. The device is

equipped with intrinsically safe input circuits

and can be installed in zone 2. A DIP switch

allows toggling of the device between 2-channel or 1-channel operating mode with signal

doubling. The output circuits are equipped

with two potential-free transistors with a high

cut-off frequency (10 kHz). The device can be

powered from a power bridge that also transmits a collective fault signal. The device complies with the requirements of NE21.

The devices feature DIP switches on the

front. This allows to select between the output

mode, the input circuit monitoring, as well as

toggle between signal duplication and 1-channel operation. When using mechanical contacts, either line monitoring must be switched

off or the contact must be wired with resistors

(see wiring diagram).

The green LED indicates operational readiness. An error in the input circuit causes the

red LED to flash according to NE44. The transistor of the associated output circuit then

locks and the common alarm output switches

to conductive.

The device can be used in safety circuits up to

SIL2 (high and low demand according to IEC

61508).

The device is equipped with removable spring

type terminals.

■ 2 transistor outputs (e 10kHz)

■ Switchable: 2-channel or signal doubling

■ Output mode adjustable (NO/NC mode)

■ Input circuits monitored for wire-break/

short-circuit (ON/OFF switchable)

■ Complete galvanic isolation

■ Input reverse-polarity protected

■ Removable spring type terminals

■ Power bridge (connector incl. in delivery)

■ ATEX, IECEx, NEPSI, cUL, cFM, INMETRO, Kosha, TIIS, TR CU EAC, DNV,

GL

■ Installation in zone 2

■ SIL 2