34350中文資料安普數(shù)據(jù)手冊PDF規(guī)格書

Features

? Si?, Si Command Language (SCL) or SiNet Hub programming

languages included with drive

? AC input 110V or 220V switch selectable, 50-60 Hz

? DC bus voltage 75 VDC full load, 80 VDC nominal

? Software selectable motor current from 0.5 – 5.5

amps/phase

? Software selectable motor resolution from 2,000 to

50,800 steps per revolution

? Software selectable idle current reduction 0, 25,

50 or 100

? Eight optically isolated programmable inputs 5 – 24

VDC. 2,200 ohms internal resistance. Can be configured

for sinking (NPN) or sourcing (PNP) signals.

? Three optically isolated programmable outputs 12 –

24 VDC, 100mA maximum

? One optically isolated output 5 VDC dedicated to fault

out

? RS-232 for PC/MMI communications

? Over current and over temperature protection

? 440 watts of usable power

? Screw terminal connectors

? Dual, MOSFET H-bridge, 3 state, pulse width modulated

amplifier switching at 20 – 30 KHz

? Ideal for 4, 6 or 8 leaded step motors NEMA sizes 23

& 34

? Optional Man Machine Interface (MMI) allows machine

operator to enter specific motion parameters

? CE and TUV compliant

Description

The Si5580 is a programmable stepper drive/indexer

packaged in a rugged steel case painted black with white

epoxy silkscreen. Integral heat sink, mounting brackets,

switch covers and connectors are included with each

Si5580. The drive/indexer has been matched with twelve

recommended NEMA 23 & 34 motors and comes with all

operating software necessary to create a complete stepper

motion solution.

The Si5580 includes Applied Motion Products’,

Microsoft Windows based, Si? software language for

quick set up and ease of use. The Si? is ideal for standalone

operation. For more experienced users, with software

development expertise, the Si5580 also comes with

Applied’s Si Command Language (SCL) programming

instruction set. SCL allows for control of the Si? drive

from a host PC or PLC thus permitting the user to perform

a variety of motion, I/O tasks and system status retrieval

via the host.

Multiple axis applications are handled by our SiNet? Hub

Programmer, which gives you the ability to control up to 8

Si? drives, either stepper or servo on the same hub. Not

only can you coordinate up to eight motors, the hub also

has access to the inputs and outputs of all the drives, providing

your program with up to 64 inputs and 24 outputs.

You can also use Applied’s MMI which allows the machine

operator to enter specific motion commands.

Factory set to operate at 110-volt input; the Si5580 can be

set by the user to operate at 220-volt input by a simply

switch selection.

Pluggable screw terminal blocks are provided for the

I/O, motor and AC power inputs. Mating connectors,

programming cable with computer interface connector

as well as all operating software are provided with each

Si? drive.

The Si5580 is both CE and TUV compliant.