1 General description

The 74ALVCH16500 is a high-performance CMOS product. This device is an 18-bit

universal transceiver featuring non-inverting 3-state bus compatible outputs in both

send and receive directions. Data flow in each direction is controlled by output enable

(OEAB and OEBA), latch enable (LEAB and LEBA), and clock (CPAB and CPBA) inputs.

For A-to-B data flow, the device operates in the transparent mode when LEAB is HIGH.

When LEAB is LOW, the A data is latched if CPAB is held at a HIGH or LOW logic level.

If LEAB is LOW, the A data is stored in the latch/flip-flop on the HIGH-to-LOW transition

of CPAB. When OEAB is HIGH, the outputs are active. When OEAB is LOW, the outputs

are in the high-impedance state.

Data flow for B-to-A is similar to that of A-to-B but uses OEBA, LEBA and CPBA.

The output enables are complimentary (OEAB is active HIGH, and OEBA is active LOW).

To ensure the high impedance state during power up or power down, OEBA

should be tied to VCC through a pullup resistor and OEAB should be tied to GND

through a pulldown resistor; the minimum value of the resistor is determined by the

current-sinking/current-sourcing capability of the driver.

Active bus-hold circuitry is provided to hold unused or floating data inputs at a valid logic

level.

2 Features and benefits

? CMOS low power consumption

? MultiByte flow-through standard pin-out architecture

? Low inductance multiple VCC and GND pins for minimum noise and ground bounce

? Direct interface with TTL levels (2.7 V to 3.6 V)

? Bus hold on data inputs

? Output drive capability 50 Ω transmission lines at 85 °C

? Current drive ±24 mA at 3.0 V

? Complies with JEDEC standards:

– JESD8-5 (2.3 V to 2.7 V)

– JESD8B/JESD36 (2.7 V to 3.6 V)

? ESD protection:

– HBM ANSI/ESDA/JEDEC JS-001 exceeds 2000 V

– CDM JESD22-C101E exceeds 1000 V

74ALVCH16500DGG屬于集成電路（IC） > 通用總線功能。安世半導體(中國)有限公司制造生產的74ALVCH16500DGG通用總線功能通用總線功能系列產品是元件級產品，用于處理或操作一系列（通常為 8 個或更多）并行邏輯信號（稱為總線）。所執行的功能包括臨時存儲要發送或接收的數據，執行緩沖以允許輸出電流容量有限的器件（例如微處理器）通過遠距離互連高速傳輸數據，以及調換或移動總線內的位順序等。