7525111中文資料圖爾克數(shù)據(jù)手冊PDF規(guī)格書

The 1-channel isolating transducer

IM33-14EX-CDRI is designed to operate intrinsically safe transmitters in the Ex area and

to transmit the measured signals to the nonEx area.

The device is equipped with an analog output of 0/4…20 mA; In addition, three relay outputs for limit values are available. The measured value can be viewed on a 2-line display.

A green LED indicates operational readiness,

3 yellow LEDs indicate the switching status of

the individual channels.

The measured value is permanently written to

a ring buffer with space for 8000 values. The

writing process is stopped with a predefined

trigger event, like for example excess of limit

value. After that, the stored signal sequence

can be read out.

The device can be parametrized and configured via PC (FDT / DTM). For this, connect

the device to the PC via the 3.5 mm jack on

the front (the matching transmission cable

IM-PROG III can be ordered separately from

TURCK). In addition, a basic scope of parameters can be set via buttons and display

on the front as well as via the HART?

capable

power interface

■ Monitoring of analog values and ranges

according to over and underrange

■ Line monitoring

■ Parameterized via PC (FDT/DTM), frontpanel switch or HART

■ Ring buffer for up to 8000 measured values

■ Display

■ Power supply of 2 and 3-wire measuring

transducers

■ Suited for active and passive signals

■ Output circuit: 0/4…20 mA, reversible

■ 3 relay outputs

■ Universal operating voltage

■ Complete galvanic isolation

■ Input reverse-polarity protected

■ ATEX, IECEx, TR CU, KOSHA

■ Installation in zone 2