7525111中文資料圖爾克數(shù)據(jù)手冊PDF規(guī)格書

The temperature measuring amplifier

IM34-12EX-CRI/K63 is designed to evaluate

the temperature-dependent changes of RTDs,

thermocouples or low voltages and to output

them as temperature-linear current signals between 0/4…20 mA. The special device K63

analyzes standard Pt100/NI100 RTDs acc.

to IEC 751, as well as Pt100 acc. to Gost, also CU50, CU53 CU100 and CuZn100 acc.to

Gost.

Moreover, standard thermocouples B, E, J, K,

L, N, R, S and T , also the types L, A1, A2, A3

and M acc. to Gost can be connected. The device has an additional relay output to monitor

over or undershoot of a limit value.

The devices are parametrized and configured

via PC with the software tool Device Type

Manager (DTM). For this, connect the temperature measuring amplifier to the PC with

the 3.5 mm jack plug on the front.

The ready-made transmission cable can be

ordered from TURCK under the type name

IM-PROG (ident no. 6890422).

The following settings can be made via DTM:

■ Connection mode (2, 3 and 4-wire technology)

■ Measuring range, start

■ Measuring range, end

■ Limit value

■ Input circuit monitoring for wire-break

■ Behaviour of current output in the event of

input circuit errors: (0 or > 22 mA)

■ Internal or external cold junction compensation

■ Output current (0/4…20 mA)

■ Temperature (°C or °K)

■ Mode (resistor, thermocouple, low voltage,

line compensation)

■ Connection of thermocouples acc. to IEC

751 and GOST

■ Connection of thermocouples acc. to IEC

584 and GOST

■ Parametrized via FDT / DTM

■ Complete galvanic isolation

■ Input reverse-polarity protected

■ ATEX, IECEx, CFMUS, UL, TR CU, INMETRO, CCOE

■ Installation in zone 2