ALD1704BSAL中文資料ADL數據手冊PDF規格書

GENERAL DESCRIPTION

The ALD1704A/ALD1704B/ALD1704/ALD1704G is a CMOS monolithic

operational amplifier with MOSFET input that has rail-to-rail input and

output voltage ranges. The input voltage range and output voltage range

are very close to the positive and negative power supply voltages.

Typically the input voltage can be beyond positive power supply voltage

V+, or the negative power supply voltage V- by up to 300mV. The output

voltage swings to within 60mV of either positive or negative power supply

voltages at rated load.

This device is designed as an alternative to the popular JFET input

operational amplifiers in applications where lower operating voltages,

such as 9V battery or ±3.25V to ±5V power supplies are being used. It

offers high slew rate of 5V/μs at low operating power of 30mW. Since the

ALD1704A/ALD1704B/ALD1704/ALD1704G is designed and manufactured

with Advanced Linear Devices' standard enhanced ACMOS silicon

gate CMOS process, it also offers low unit cost and exceptional reliability.

The rail-to-rail input and output feature of the ALD1704A/ALD1704B/

ALD1704/ALD1704G allows a lower operating supply voltage for a given

signal voltage range and allows numerous analog serial stages to be

implemented without losing operating voltage margin. The output stage

is designed to drive up to 10mA into 400pF capacitive and 1.5KΩ resistive

loads at unity gain and up to 4000 pF at a gain of 5. Short circuit protection

to either ground or the power supply rails is at approximately 15mA clamp

current. Due to complementary output stage design, the output can both

source and sink 10mA into a load with symmetrical drive and is ideally

suited for applications where push-pull voltage drive is desired.

The offset voltage is trimmed on-chip to eliminate the need for external

nulling in many applications. For precision applications, the output is

designed to settle to 0.1 in 2μs. For large signal buffer applications, the

operational amplifier can function as an ultra high input impedance

voltage follower/buffer that allows input and output voltage swings from

positive to negative supply voltages. This feature is intended to greatly

simplify systems design and eliminate higher voltage power supplies in

many applications. Additionally, robust design and rigorous screening

make this device especially suitable for operation in temperature-extreme

environments and rugged conditions.

APPLICATIONS

? Voltage amplifier

? Voltage follower/buffer

? Charge integrator

? Photodiode amplifier

? Data acquisition systems

? High performance portable

instruments

? Signal conditioning circuits

? Low leakage amplifiers

? Active filters

? Sample/Hold amplifier

? Picoammeter

? Current to voltage converter

? Coaxial cable driver

? Capacitive sensor amplifier

? Piezoelectric transducer amplifier

FEATURES

? Rail-to-rail input and output voltage ranges

? 5.0V/μs slew rate

? Output settles to 2mV of supply rails

? High capacitive load capability -- up to 4000pF

? Symmetrical push-pull output drives

? No frequency compensation required --

unity gain stable

? Extremely low input bias currents -- 1.0pA

typical (20pAMax)

? Ideal for high source impedance applications

? High voltage gain -- typically 150V/mV

? Output short circuit protected

? Unity gain bandwidth of 2.1MHz

? Suitable for rugged, temperature-extreme

environments