CPS-1616中文資料瑞薩數(shù)據(jù)手冊PDF規(guī)格書

Features

? RapidIO ports

— 16 bidirectional S-RIO lanes

— Port widths of 1x, 2x, and 4x allow up to 20 Gbps per port

— Port speeds selectable: 6.25, 5, 3.125, 2.5, or 1.25 Gbaud

— Support Level I defined short or long haul reach, and Level II

defined short-, medium-, or long-run reach for each PHY speed

— Error Management Extensions support

— Software-assisted error recovery, supporting hot swap

? I2C Interfaces

— Provides I2C port for maintenance and error reporting

— Master or Slave operation

— Master allows power-on configuration from external ROM

— Master mode configuration with external image compressing and

checksum

? Switch

— 80 Gbps peak throughput

— Non-blocking data flow architecture

— Configurable for Cut-Through or Store-and-Forward data flow

— Very low latency for all packet lengths and load conditions

— Internal queuing buffer and retransmit buffer

— Standard transmitter- or receiver-controlled flow control

— Global routing or Local Port routing capability

— Supports up to 40 simultaneous multicast masks, with broadcast

— Performance monitoring counters for performance and

diagnostics analysis. Per input port and output port counters

? SerDes

— Transmitter pre-emphasis and drive strength + receiver

equalization provides best possible signal integrity

— Embedded PRBS generation and detection with programmable

polynomials support Bit Error Rate testing

? Additional Information

— Packet Trace/Mirror. Each input port can copy all incoming

packets matching user-defined criteria to a “trace” output port.

— Packet Filter. Each input port can filter (drop) all incoming packets

matching user-defined criteria.

— Device configurable through any of S-RIO ports, I2C, or JTAG

— Full JTAG Boundary Scan Support (IEEE1149.1 and 1149.6)

— Lidded/Lidless 784-FCBGA Package: 21 ??21 mm, 1.0 mm ball

pitch