CY15FRAMKIT-002開發板套件編程器的評估演示板及套件規格書PDF中文資料

1.1 Kit Contents

The CY15FRAMKIT-002 Kit includes the following contents:

? CY15FRAMKIT-002 DVK board with CY15B104QSN-108SXI, 108-MHz 4-Mbit Quad SPI F-RAM

? Quick Start Guide

? Arduino Stackable Headers for connector expansion

1.2 Getting Started

This guide helps you to get acquainted with the CY15FRAMKIT-002 DVK. The Pre-requisite Software section describes the

software required to use the driver set provided for this kit. The Kit Overview chapter explains the features of the kit. The

Kit Operation chapter explains how to program and run the kit. The Appendix B explains the GUI to test out the QSPI FRAM

features. The Firmware Details chapter the F-RAM access API and a link to download the example project. Appendix

A provides the kit block diagram, schematics, pin assignment, and the bill of materials (BOM)

1.3 Pre-requisite Software

? Keil μVision 5 software (for development and programming)

? STSW-LINK009 - ST-LINK, ST-LINK/V2, ST-LINK/V2-1 USB driver signed for Windows 7, Windows 8, Windows 10

? STSW-LINK007 - ST-LINK, ST-LINK/V2, ST-LINK/V2-1 firmware upgrade

1.4 Pre-requisite Hardware

? NUCLEO-L433RC-P: STM32 Nucleo64 Evaluation Board (details)

? CY15FRAMKIT-002 DVK board

1.5 Additional Resources

? Details about the ST Micro-electronics Kit can be found here.

? Details about Keil μVision installation can be found here (download MDK-Arm tool chain).

? The example project and firmware files are part of the compressed folder downloaded from the Cypress Community.

? The datasheet for Cypress Quad SPI F-RAM mounted on the kit can be downloaded from here.