CYALKIT-E03開發(fā)板套件編程器的評(píng)估板-擴(kuò)展板子卡規(guī)格書PDF中文資料

The CYALKIT-E03 Solar-Powered BLE Sensor Beacon 5 Pack provides everything needed to develop a light-powered

sensor node that transmits sensor data using Bluetooth Low Energy (BLE):

? Tiny solar-powered BLE sensor board (circle with 24-mm diameter, same size as 25-cent coin)

? Operates using light energy harvested (>100 lux) by the included solar cell

? Supports BLE communication with a mobile device (iOS 8 or newer/Android 4.4 or newer)

? Energy harvesting PMIC S6AE103A that supports the following applications:

□ Demo mode, transmitting sensor data at 3- to 60-second intervals (without charging to a supercapacitor)

□ Timer mode, transmitting sensor data at 5-minute intervals while charging to the supercapacitor

□ Transmitting data at over 30 hours without ambient light (when mode is set to Timer mode and supercapacitor is

fully charged)

? Solar BLE Sensor that can support the following:

□ Selection of mode using a slide switch (Demo or Timer mode)

□ Programming and debugging of the EZ-BLE module via Debug Board

□ Parameter setting of BLE Beacon via Debug Board

□ Charging of surplus solar energy to a 0.2-F supercapacitor (Timer mode)

□ Charging of supercapacitor via Debug Board using USB bus power

□ Temperature and humidity digital sensor

□ Expandable interface via 10-pin connector (GPIO)

□ Test pads for power, ground, primary battery input, and SWD interface for programming

Uses the following Cypress devices:

□ S6AE103A ultra-low-power energy harvesting PMIC

□ CYBLE-022001-00 EZ-BLE PRoC module

In this chapter, you will become familiar with the Solar-Powered BLE Sensor Beacon 5 Pack by successfully establishing a

BLE sensor beacon connection between the Solar BLE Sensor operating as a wireless sensor network (WSN), a mobile

device with apps. This will also confirm that the Solar BLE Sensor and your mobile device are operating properly.