FT2232D集成電路（IC）的控制器規格書PDF中文資料
| 廠商型號 |
FT2232D |
| 參數屬性 | FT2232D 封裝/外殼為48-LQFP；包裝為托盤；類別為集成電路（IC）的控制器；產品描述：IC USB FS DUAL UART/FIFO 48LQFP |
| 功能描述 | Dual USB UART/FIFO I.C. |
| 封裝外殼 | 48-LQFP |
| 文件大小 |
952.14 Kbytes |
| 頁面數量 |
56 頁 |
| 生產廠商 | Future Technology Devices International Ltd. |
| 企業簡稱 |
FTDI【飛特帝亞】 |
| 中文名稱 | 英商飛特帝亞有限公司官網 |
| 原廠標識 |  |
| 數據手冊 | |
| 更新時間 | 2025-1-23 9:22:00 |
FT2232D規格書詳情
General Description
The FT2232D is a USB interface which incorporates the functionallity of two of FTDI’s second generation BM chips into a single device. A single downstream USB port is converted to two IO channels which can each be individually configured as a FT232BM-style UART interface, or a FT245BM-style FIFO interface, without the need to add a USB hub. There are also several new special modes which are either enabled in the external EEPROM, or by using driver commands. These include Synchronous Bit-Bang Mode, a CPU-Style FIFO Interface Mode, a Multi-Protocol Synchronous Serial Engine Interface Mode, MCU Host Bus Emulation Mode, and Fast Opto-Isolated Serial Interface Mode.
Features Summary
Hardware Features
? Single chip USB to dual channel serial / parallel ports with a variety of configurations.
? Entire USB protocol handled on the chip...no USB specific firmware programming required.
? FT232B-style asynchronous serial UART interface option with full hardware handshaking and modem interface signals.
? UART Interface supports 7 / 8 bit data, 1 / 2 stop bits, and Odd / Even / Mark / Space / No Parity
? Fully assisted hardware or X-On / X-Off software handshaking.
? Transfer Data Rate 300 to 1 Mega Baud (RS232).
? Transfer Data Rate 300 to 3 Mega Baud (at TTL levels and RS422 / RS485).
? Auto transmit enable control for RS485 serial applications using TXDEN pin.
? In-built support for event characters and line break condition.
? Transmit and receive LED drive signals on each channel.
? FT245B-style FIFO interface option with bidirectional data bus and simple 4 wire handshake interface.
? USB to parallel FIFO transfer data rate up to 1 megabyte / second.
? Adjustable receive buffer timeout.
? Enhanced bit-bang Mode interface option with RD# and WR# strobes.
? New synchronous bit-bang mode interface option with RD# and WR# strobes.
? New Multi-Protocol Synchronous Serial Engine (MPSSE) interface option.
? New CPU-style FIFO interface mode option.
? New MCU host bus emulation mode option.
? New fast opto-Isolated serial interface mode option
? High I/O pin output drive option.
? Interface mode and USB Description strings configurable in external EEPROM.
? EEPROM Configurable on board via USB
? Support for USB suspend and resume conditions via PWREN#, and SI/WU pins.
? Support for bus powered, self powered, and high power bus powered USB configurations.
? Integrated power-on-reset circuit, with optional reset input and reset Output pins.
? 5V and 3.3V logic I/O Interfacing with independent level conversion on each channel.
? Integrated 3.3V LDO regulator for USB I/O
? Integrated 6MHz – 48Mhz clock multiplier PLL
? USB Bulk data transfer mode.
? 4.35V to 5.25V single supply operating voltage range.
? Low operating and USB suspend current.
? UHCI / OHCI / EHCI host controller compatible.
? USB 2.0 Full Speed (12 Mbits / Second) compatible.
? Extended -40°C to 85°C industrial operating tem perature range.
? Compact 48-LD Lead Free LQFP package
? FTDI’s royalty-free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases.
? Dedicated Windows DLLs available for USB to JTAG, USB to SPI, and USB to I2C applications.
Typical Applications
? USB to Dual Port RS232 Converters
? USB to Dual Port RS422 / RS485 Converters
? Upgrading Legacy Peripheral Designs to USB
? USB Instrumentation
? USB JTAG Programming
? USB to SPI Bus Interfaces
? USB Industrial Control
? Field Upgradable USB Products
? Galvanically Isolated Products with USB Interface
? USB to synchronous serial interface
? Cellular and cordless phone USB data transfer cables and interfaces.
? Interfacing MCU / PLD / FPGA based designs to USB
? USB Audio and Low Bandwidth Video data transfer
? PDA to USB data transfer
? USB Smart Card Readers
? USB Instrumentation
? USB Industrial Control
? USB MP3 Player Interface
? USB FLASH Card Reader / Writers
? Set Top Box PC - USB interface
? USB Digital Camera Interface
? USB Bar Code Readers
產品屬性
- 產品編號：
FT2232D-TRAY
- 制造商：
FTDI, Future Technology Devices International Ltd
- 類別：
集成電路（IC） > 控制器
- 系列：
USBmadeEZ-FIFO, FT-X, X-Chip
- 包裝：
托盤
- 協議：
USB
- 功能：
橋，USB 至 UART
- 接口：
UART
- 標準：
USB 2.0
- 電壓 - 供電：
4.35V ~ 5.25V
- 電流 - 供電：
30mA
- 工作溫度：
-40°C ~ 85°C
- 封裝/外殼：
48-LQFP
- 供應商器件封裝：
48-LQFP（7x7）
- 描述：
IC USB FS DUAL UART/FIFO 48LQFP
| 供應商 | 型號 | 品牌 | 批號 | 封裝 | 庫存 | 備注 | 價格 |
|---|---|---|---|---|---|---|---|
DLP/FTDI |
24+ |
原廠原裝 |
5000 |
原裝正品 |
詢價 | ||
FTDI |
23+/24+ |
LQFP48 |
15000 |
原裝進口、正品保障、合作持久 |
詢價 | ||
進口FTDI現貨可做含稅 |
24+ |
FTDISZ |
9000 |
只做原裝正品 有掛有貨 假一賠十 |
詢價 | ||
FTDI |
23+ |
QFP |
65480 |
詢價 | |||
FTDI |
2020+ |
LQFP-48 |
80000 |
只做自己庫存,全新原裝進口正品假一賠百,可開13%增 |
詢價 | ||
FTDI |
24+ |
N/P |
16500 |
代理授權直銷,原裝現貨,假一罰十,長期穩定供應 |
詢價 | ||
FTDI |
23+ |
LQFP48 |
7750 |
全新原裝優勢 |
詢價 | ||
FTDI/飛特帝亞 |
22+ |
LQFP48 |
18000 |
原裝正品 |
詢價 | ||
FTDI |
21+ |
8080 |
只做原裝,質量保證 |
詢價 | |||
FTDI |
23+/24+ |
LQFP48 |
9865 |
主營品牌.進口環保.原盤原標 |
詢價 |
