Features

? Programmable for stand alone operation with Applied

Motion’s easy to use Si Programmer? Windows software

(software and programming cable included)

? Can be operated in real time from a host PC or PLC using Applied

Motion’s Si Command Language? (SCL)

? Can be networked with all other Si? products via Applied

Motion’s SiNet? Hub

? DC bus voltage 24-80 VDC motor supply (including ripple)

? Software selectable from 0.8–7.0 amps/phase motor current

? Software selectable Step resolutions from 2,000 to 50,800

steps per revolution

? Software selectable idle current reduction 0, 25, 50

or 100

? 8 user programmable inputs

? 3 optically isolated 24 VDC outputs

? Short circuit and over temperature protection

? Communication via RS232

? 560 watts of usable power

? Screw terminal connector blocks for power and motor,

Wago cage clamp connector for I/O. RJ11 for RS232 port

? MOSFET, dual H-bridge, inaudible PWM amplifier

? 3 state, pulse width modulated current control, switching at

20–30 kHz

? Optional operator terminal (MMI) either standard or backlit

? Drives 4, 6 or 8 lead size 11, 14, 17, 23 and 34 step motors

? CE compliant

Description

The 7080i is a programming step motor driver suitable for a wide

range of motion control applications. It includes a sophisticated

controller integrated with a 560-watt microstepping amplifier.

The 7080i includes Applied Motion’s easy to use Si Programmer

? Windows software for the rapid development of stand

alone motion control programs. The 7080i can also be commanded

in real time from a host PC or PLC, using the Si Command

Language?.

For multi-axis applications, up to eight Applied Motion Si?

drives (stepper or Servo) can be networked using a single

SiNet? Hub.

The 7080i includes 8 programmable inputs for triggering,

branching, position sensing and end of travel detection. 3 optically

isolated programmable outputs can send signals to other

electronic devices and activate relays.

The 7080i is a PC board mounted on an aluminum angle heat

transfer chassis. Drive dimensions are 2? by 3? by 6?.