IDT2308-2DC集成電路（IC）的時(shí)鐘發(fā)生器PLL頻率合成器規(guī)格書PDF中文資料

DESCRIPTION:

The IDT2308 is a high-speed phase-lock loop (PLL) clock multiplier. It is designed to address high-speed clock distribution and multiplication applications. The zero delay is achieved by aligning the phase between the incoming clock and the output clock, operable within the range of 10 to 133MHz.

The IDT2308 has two banks of four outputs each that are controlled via two select addresses. By proper selection of input addresses, both banks can be put in tri-state mode. In test mode, the PLL is turned off, and the input clock directly drives the outputs for system testing purposes. In the absence of an input clock, the IDT2308 enters power down, and the outputs are tri-stated. In this mode, the device will draw less than 25μA.

FEATURES:

? Phase-Lock Loop Clock Distribution for Applications ranging from 10MHz to 133MHz operating frequency

? Distributes one clock input to two banks of four outputs

? Separate output enable for each output bank

? External feedback (FBK) pin is used to synchronize the outputs to the clock input

? Output Skew <200 ps

? Low jitter <200 ps cycle-to-cycle

? 1x, 2x, 4x output options (see table):

– IDT2308-1 1x

– IDT2308-2 1x, 2x

– IDT2308-3 2x, 4x

– IDT2308-4 2x

– IDT2308-1H, -2H, and -5H for High Drive

? No external RC network required

? Operates at 3.3V VDD

? Available in SOIC and TSSOP packages