The ISL6225 dual PWM controller delivers high efficiency and tight regulation from two voltage regulating synchronous buck DC/DC converters. The ISL6225 PWM power supply controller was designed especially for DDR DRAM, SDRAM, and graphic chipset applications in high performance desknote PCs, notebook PCs, sub-notebook PCs, and PDAs.

Automatic mode selection of constant-frequency synchronous rectification at heavy load, and hysteretic diode-emulation at light load, assure high efficiency over a wide range of conditions. The hysteretic mode of operation can be disabled separately on each PWM converter if constant-frequency continuous-conduction operation is desired for all load levels. Efficiency is further enhanced by using the lower MOSFET rDS(ON) as the current sense element.

Features

? Provides regulated output voltage in the range of 0.9V-5.5V

- High efficiency over wide load range

- Synchronous buck converter with hysteretic operation at light load

- Inhibit Hysteretic mode on one, or both channels

? Complete DDR memory power solution

- VTT tracks VDDQ/2

- VDDQ/2 buffered reference output

? No current-sense resistor required

- Uses MOSFET rDS(ON)

- Optional current-sense resistor for precision overcurrent

? Under-voltage lock-out on VCC pin

? Dual input voltage mode operation

- Operates directly from battery 5V to 24V input

- Operates from 3.3V or 5V system rail

- VCC from 5V only

? Excellent dynamic response

- Combined voltage feed-forward and average current mode control

? Power-good signal for each channel

? 300kHz switching frequency

- 180° channel to channel phase operation for reduced input ripple when not in DDR mode

- 0° channel to channel phase operation in DDR mode for reduced channel interference

- 90° channel to channel phase operation for reduced input ripple in DDR mode when VIN is at GND.

? Pb-Free Available (RoHS Compliant)

Applications

? Mobile PCs

? PDAs

? Hand-held portable instruments