1 Features

? AEC-Q100 qualified for automotive applications

– Temperature grade 1: –40°C to +125°C TA

? Functional Safety-Capable

– Documentation available to aid functional safety

system design

? Wide input operating range for car and portable

battery applications

– 3.5-V to 45-V Operating range

– 2.97-V to 16-V When BIAS = VCC

– Minimum boost supply voltage 1.5 V when

BIAS ≥ 3.5 V

– Input transient protection up to 50 V

? Minimized battery drain

– Low shutdown current (IQ ≤ 2.6 μA)

– Low operating current (IQ ≤ 480 μA)

? Small solution size and low cost

– Maximum switching frequency of 2.2 MHz

– 12-Pin WSON package (3 mm × 2 mm) with

wettable flanks

– Integrated error amplifier allows primary-side

regulation without optocoupler (flyback)

– Minimized undershoot during cranking (startstop

application)

? Higher efficiency with low-power dissipation

– 100-mV ±7 Low current limit threshold

– Strong 1.5-A peak standard MOSFET driver

– Supports external VCC supply

? Avoid AM band interference and crosstalk

– Optional clock synchronization

– Dynamically programmable switching frequency

from 100 kHz to 2.2 MHz

? Integrated protection features

– Constant peak current limiting over input

voltage

– Optional hiccup mode short-circuit protection

(see the Device Comparison Table)

– Programmable line UVLO

– OVP protection

– Thermal shutdown

? Accurate ±1 accuracy feedback reference

? Programmable extra slope compensation

? Adjustable soft start

? PGOOD indicator

? Create a custom design using the LM5155x with

the WEBENCH? power designer

2 Applications

? Automotive start-stop application

? High voltage LiDAR power supply

? Multiple-output flyback without optocoupler

? Automotive rear-lights LED bias supply

? Wide input boost, SEPIC, flyback power module

? Portable speaker application

? Battery-powered boost, SEPIC, flyback

3 Description

The LM5155x-Q1 (LM5155-Q1 and LM51551-Q1) is a

wide input range, non-synchronous boost controller

that uses peak current mode control. The device can

be used in boost, SEPIC, and flyback topologies.

The LM5155x-Q1 can start up from a 1-cell battery

with a minimum of 2.97 V if the BIAS pin is connected

to the VCC pin. It can operate with the input supply

voltage as low as 1.5 V if the BIAS pin is greater than

3.5 V.

LM51551屬于集成電路（IC） > PMIC - 穩(wěn)壓器 - DC DC 開關式控制器。美國德州儀器公司制造生產(chǎn)的LM51551DC-DC 開關控制器PMIC（電源管理集成電路）DC 到 DC 開關式控制器是用于高效率電路的穩(wěn)壓 IC，其配置為生成高于（突升或步升）或低于（突降或步降）輸入電源的輸出電源電壓。其他拓撲結構可能包括：降壓-升壓、反激、正激、Cuk、SEPIC、全橋、半橋和推挽式。這些器件不同于需要最小電壓并“燒盡”多余電壓的線性穩(wěn)壓器。