LM51772RHAR中文資料德州儀器數(shù)據手冊PDF規(guī)格書

1 Features

? Input range from 3.5V to 55V

? Output voltage 3.3V to 55V

? Dynamical Vo programming via I2C from 3.3V

– up to 48V in 20mV monotonous steps

– up to 24V in 10mV monotonous steps

? Peak current regulation scheme

? Small voltage transition ripple over all operating

modes

? Dynamic output voltage tracking (digital PWM

tracking input, analog tracking input)

– Via I2C interface programming

? Shut down quiescent current 3μA

? Operating quiescent current 60μA

? DRV pin for external FET control

? Operation mode selection for high efficiency in light

load and high load conditions:

– Power save mode (burst/μSleep)

– Automatic/programmable conduction mode

? Integrated high voltage supply LDO

? Axillary high voltage LDO/reference

? Integrated full-bridge gate drive

– 2A peak current capability

– Bootstrap over and under-voltage protection

– Integrated boot-strap diode

? Fixed frequency independent from operating mode

(boost, buck-boost, buck)

– Forced PWM mode selectable

– Switching frequency from 100kHz to 2.2MHz

– External clock synchronization and clock output

? Spread spectrum operation selectable

? High-side output current sensor

– Programmable from 1A to 7A in 50mA steps

– ISET pin selectable

? I2C Interface readout of (device configuration,

enhanced monitoring features, programmable

thermal warning)

? Create a custom design using the LM51772 with

the WEBENCH? Power Designer

2 Applications

? USB Type-C power delivery (Docking station, PCmonitor,

Desktop PC)

? Wireless charging

? Industrial PC/ Rugged PC

? Battery backup unit

? Merchant DC/DC

? avionics / marine sonar

? Off-highway vehicle

3 Description

The LM51772 is a four switch Buck-Boost controller.

It provides a regulated output voltage if the input

voltage is higher, equal or lower than the adjusted

output voltage. In power save mode the device

supports very high efficiency over the complete

operation range of the output. The LM51772 runs

at a fixed switching frequency, which can be set via

the RT/SYNC pin. The switching frequency remains

constant during buck, boost and buck-boost operation

in forced PWM. The external compensation pin allows

very fast transient responds for different applications.

(Continued)