LM75ADP傳感器變送器的溫度傳感器-模擬數(shù)字輸出規(guī)格書PDF中文資料

GENERAL DESCRIPTION

The LM75A is a temperature-to-digital converter using an on-chip band-gap temperature sensor and Sigma-delta A-to-D conversion technique. The device is also a thermal detector providing an over-temp detection output. The LM75A contains a number of data registers: Configuration register (Conf) to store the device settings such as device operation mode, OS operation mode, OS polarity and OS fault queue as described in the functional description section; temperature register (Temp) to store the digital temp reading, and set-point registers (Tos & Thyst) to store programmable overtemp shutdown and hysteresis limits, that can be communicated by a controller via the 2-wire serial I2C-bus interface. The device also includes an open-drain output (OS) which becomes active when the temperature exceeds the programmed limits. There are three selectable logic address pins so that eight devices can be connected on the same bus without address conflict.

The LM75A can be configured for different operation conditions. It can be set in normal mode to periodically monitor the ambient temperature, or in shutdown mode to minimize power consumption. The OS output operates in either of two selectable modes: OS comparator mode and OS interrupt mode. Its active state can be selected as either HIGH or LOW. The fault queue that defines the number of consecutive faults in order to activate the OS output is programmable as well as the set-point limits.

FEATURES

? Pin-for-pin replacement for industry standard LM75 and offers improved temperature resolution of 0.125 °C and specification of a single part over power supply range from 2.8 V to 5.5 V.

? Small 8-pin package types: SO8 and TSSOP8

? I2C-bus interface with up to 8 devices on the same bus

? Power supply range from 2.8 V to 5.5 V

? Temperatures range from –55 °C to +125 °C

? 11-bit ADC that offers a temperature resolution of 0.125 °C

? Temperature accuracy of:

±2 °C from –25 °C to +100 °C

±3 °C from –55 °C to +125 °C

? Programmable temperature threshold and hysteresis set points

? Supply current of 3.5 μA in shut-down mode for power conservation

? Stand-alone operation as thermostat at power-up.

? ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per JESD22-A115 and 1000 V CDM per JESD22-C101

? Latch-up testing is done to JESDEC Standard JESD78 which exceeds 100 mA

APPLICATIONS

? System thermal management

? Personal computers

? Electronics equipment

? Industrial controllers.