LNBP13SP集成電路（IC）的特殊用途穩壓器規格書PDF中文資料

LNBP13SP屬于集成電路（IC）的特殊用途穩壓器。由意法半導體集團制造生產的LNBP13SP特殊用途穩壓器該系列產品用于電源控制、某種形式的轉換，適用于特定的復雜應用。因此，各種產品特性集差異較大，包括空燃比傳感器接口、汽車交流發電機電壓調節、DDR 端接、液體透鏡控制、摩托車轉向信號控制、熱電 (peltier) 冷卻器控制、壓電觸覺控制、閥門控制、小型發動機管理等。

Description

Intended for analog and digital satellite receivers, the LNBP is a monolithic linear voltage regulator, assembled in PowerSO-20 and PowerSO-10, specifically designed to provide the powering voltages and the interfacing signals to the LNB downconverter situated in the antenna via the coaxial cable. Since most satellite receivers have two antenna ports, the output voltage of the regulator is available at one of two logic-selectable output pins (LNBA, LNBB). When the IC is powered and put in Stand-by (EN pin LOW), both regulator outputs are disabled to allow the antenna downconverters to be supplied/controlled by others satellite receivers sharing the same coaxial lines. In this occurrence the device will limit at 3 mA (max) the backward current that could flow from LNBA and LNBB output pins to GND. (See continuous description).

Feature summary

■ Complete interface for two LNBs remote supply and control

■ LNB selection and stand-by function

■ Built-in tone oscillator factory trimmed at 22KHz

■ Fast oscillator start-up facilitates DiSEqCTM encoding

■ Two supply inputs for lowest dissipation

■ Bypass function for slave operation

■ LNB short circuit protection and diagnostic

■ Auxiliary modulation input extends flexibility

■ Cable length compensation

■ Internal over temperature protection

■ Backward current protection