M50FW016N5TG集成電路（IC）的存儲器規(guī)格書PDF中文資料

SUMMARY DESCRIPTION

The M50FW016 is a 16 Mbit (2Mb x8) non-volatile memory that can be read, erased and reprogrammed. These operations can be performed using a single low voltage (3.0 to 3.6V) supply. For fast programming and fast erasing, an optional 12V power supply can be used to reduce the programming and the erasing times.

The memory is divided into blocks that can be erased independently so it is possible to preserve valid data while old data is erased. Blocks can be protected individually to prevent accidental Program or Erase commands from modifying the memory. Program and Erase commands are written to the Command Interface of the memory. An on-chip Program/Erase Controller simplifies the process of programming or erasing the memory by taking care of all of the special operations that are required to update the memory contents. The end of a program or erase operation can be detected and any error conditions identified. The command set required to control the memory is consistent with JEDEC standards.

FEATURES SUMMARY

■ SUPPLY VOLTAGE

– VCC = 3 V to 3.6 V for Program, Erase and Read Operations

– VPP = 12 V for Fast Program and Fast Erase

■ TWO INTERFACES

– Firmware Hub (FWH) Interface for embedded operation with PC Chipsets

– Address/Address Multiplexed (A/A Mux)

Interface for programming equipment compatibility

■ FIRMWARE HUB (FWH) HARDWARE INTERFACE MODE

– 5 Signal Communication Interface supporting Read and Write Operations

– Hardware Write Protect Pins for Block Protection

– Register Based Read and Write Protection

– 5 Additional General Purpose Inputs for platform design flexibility

– Multi-byte Read Operation (4/16/128-byte)

– Synchronized with 33 MHz PCI clock

■ BYTE PROGRAMMING TIME

– Single Byte Mode: 10μs (typical)

– Quadruple Byte Mode: 2.5μs (typical)

■ 32 UNIFORM 64 Kbyte MEMORY BLOCKS

■ PROGRAM and ERASE SUSPEND

– Read other Blocks during Program/Erase Suspend

– Program other Blocks during Erase Suspend

■ FOR USE in PC BIOS APPLICATIONS

■ ELECTRONIC SIGNATURE

– Manufacturer Code: 20h

– Device Code: 2Eh