MBM29F017A-12PNS中文資料飛索數(shù)據(jù)手冊PDF規(guī)格書

■ DESCRIPTION

The MBM29F017A is a 16M-bit, 5.0 V-Only Flash memory organized as 2M bytes of 8 bits each. The 2M bytes of data is divided into 32 sectors of 64K bytes for flexible erase capability. The 8 bit of data will appear on DQ7 to DQ0. The MBM29F017A is offered in a 48-pin TSOP package. This device is designed to be programmed in system with the standard system 5.0 V VCC supply. A 12.0 V VPP is not required for program or erase operations. The device can also be reprogrammed in standard EPROM programmers.

The standard MBM29F017A offers access times between 70 ns and 120 ns allowing operation of high-speed microprocessors without wait states. To eliminate bus contention the device has separate chip enable (CE), write enable (WE), and output enable (OE) controls.

The MBM29F017A is command set compatible with JEDEC standard single-supply Flash standard. Commands are written to the command register using standard microprocessor write timings. Register contents serve as input to an internal state-machine which controls the erase and programming circuitry. Write cycles also internally latch addresses and data needed for the programming and erase operations. Reading data out of the device is similar to reading from 12.0 V Flash or EPROM devices.

■ FEATURES

? Single 5.0 V read, write, and erase

Minimizes system level power requirements

? Compatible with JEDEC-standard commands

Pinout and software compatible with single-power supply Flash

Superior inadvertent write protection

? 48-pin TSOP, 40-pin SON

? Minimum 100,000 write/erase cycles

? High performance

70 ns maximum access time

? Sector erase architecture

Uniform sectors of 64K bytes each

Any combination of sectors can be erased. Also supports full chip erase

? Embedded EraseTM Algorithms

Automatically pre-programs and erases the chip or any sector

? Embedded ProgramTM Algorithms

Automatically programs and verifies data at specified address

? Data Polling and Toggle Bit feature for detection of program or erase cycle completion

? Ready/BUSY output (RY/BY)

Hardware method for detection of program or erase cycle completion

? Low VCC write inhibit ≤ 3.2 V

? Hardware RESET pin

Resets internal state machine to the read mode

? Erase Suspend/Resume

Supports reading or programming data to a sector not being erased

? Sector group protection

Hardware method that disables any combination of sector groups from write or erase operation

(a sector groupconsists of 4 adjacent sectors of 64K bytes each)

? Temporary sector groups unprotection

Hardware method temporarily enable any combination of sectors from write or erase operations