MC44BC373CD中文資料飛思卡爾數(shù)據(jù)手冊PDF規(guī)格書

Device Overview

Figure 2 shows a simplified block diagram of the MC44BC373C/4C device. The MC44BC373C/4C device has three main sections:

1. A high speed I2C-compatible bus section

2. A PLL section to synthesize the UHF/VHF output channel frequency (from an integrated UHF oscillator, divided for VHF output)

3. A modulator section, which accepts audio and video inputs, then uses them to modulate the UHF/VHF carrier

An on-chip video test pattern generator with an audio test signal is included.

Features

MC44BC373C: Multi-Standard PAL/SECAM/NTSC Modulator

MC44BC374C: PAL/NTSC only Modulator

The channel is set by an on-chip high-speed I2C compatible bus receiver. A Phase-Locked Loop (PLL) tunes the modulator over the full UHF range.

The modulator incorporates a sound subcarrier oscillator and uses a second PLL to derive 4.5, 5.5, 6.0, and 6.5MHz subcarrier frequencies. These frequencies are selectable using the bus.

The modulation standard can be chosen using a control bit that selects between System L or System B/G (MC44BC373C only).

The picture-to-sound ratio may be adjusted using the bus. In addition, an on-chip video test pattern generator can be switched ON with a 1KHz audio test signal.

The MC44BC373C/4C also has the following features:

? No external varicaps diodes/inductor or tuned components

? Channel 21-69 UHF operation

? VHF range possible by internal dividers (30MHz–450MHz)

? Integrated on-chip programmable UHF oscillator

? Extremely low external components count

? High speed read and write I2C-bus compatible (800kHz)

? Fixed video modulation depth (80 in PAL and 90 in SECAM)

? Peak White Clip disabled via the bus

? Programmable picture/sound carrier ratio (12dB and 16dB)

? Integrated on-chip programmable sound subcarrier oscillator (4.5MHz to 6.5MHz)—No external varicaps

? On-chip video test pattern generator with sound test signal (1kHz)

? Low-power programmable modulator standby mode

? Transient output inhibit during PLL Lock-up at power-ON

? Logical Output Port controlled by bus

? Custom masked versions with unique start-up settings possible (no I2C bus programming required)

? Extremely robust ESD protection, minimum 4kV, typical 6kV