MC68HC68T1中文資料摩托羅拉數(shù)據(jù)手冊PDF規(guī)格書

Real-Time Clock plus RAM with Serial Interface CMOS

TheMC68HC68T1 HCMOS Clock/RAM peripheral contains a real–time clock/calendar,a 32x 8 static RAM, and a synchronous, serial, three–wire interface for communication with a microcontroller or processor. Operating in a

burstmode, successive Clock/RAM locations can be read or written using only asingle starting address. An on–chiposcillator allows acceptance of a selectable crystal frequency or the device can be programmed to accept a

50/60 Hz line input frequency.

? Full Clock Features — Seconds, Minutes, Hours (AM/PM), Day–of–Week, Date, Month, Year (0 – 99), Auto Leap Year

? 32–Byte General Purpose RAM

? Direct Interface to Motorola SPI and National MICROWIRE
Serial Data Ports

? Minimum Timekeeping Voltage: 2.2 V

? Burst Mode for Reading/Writing Successive Addresses in Clock/RAM

? Selectable Crystal or 50/60 Hz Line Input Frequency

? Clock Registers Utilize BCD Data

? Buffered Clock Output for Driving CPU Clock, Timer, Colon, or LCD Backplane

? Power–On Reset with First Time–Up Bit

? Freeze Circuit Eliminates Software Overhead During a Clock Read

? Three Independent Interrupt Modes — Alarm, Periodic, or Power–Down

? CPU Reset Output — Provides Orderly Power–Up/Power–Down

? Watchdog Circuit

? Pin–for–Pin Replacement for CDP68HC68T1

? Chip Complexity: 8500 FETs or 2125 Equivalent Gates

? Also See Application Notes ANE425 “Use of the MC68HC68T1 RTC with M6805 Microprocessor”, AN457 “Providing a Real–Time Clock for the MC68302”, and AN1065 “Use of the MC68HC68T1 Real–Time Clock with

Multiple Time Bases”