MC68HC812A4中文資料飛思卡爾數據手冊PDF規格書

Introduction

The MC68HC812A4 (812A4) is designed primarily as an expanded mode microcontroller. It can be operated in expanded narrow mode for 8-bit peripheral devices and in expanded wide mode for 16-bit peripheral devices.

The M68HC12A4EVB (A4EVB) is designed to accommodate expanded narrow mode of operation, although in the factory it is configured in expanded wide mode.

The steps to set up the evaluation board are described in this engineering bulletin. They are designed to help guide users to configure emulation RAM (random-access memory) in expanded narrow mode and to utilize a third-party debugger to debug in C language.

Setting up the A4EVB in special expanded narrow mode requires modifying the evaluation board.

Follow these steps to make the modification:

? When setting up the evaluation board, turn off the power to the A4EVB.

? Jumpers W42 and W34 should be shunted between pins 1 and 2. W30 should be left floating or pulled out.

? Remove the 74HC32 chip from U3.

? Make a wire jumper from pin 2 on U3 socket to pin 3. This will make a direct connection from the RAM-CS signal to RAM-MSB-CS. Chip enable (CE) on pin 22 will have a direct connection to chip select header W11.

? Select CSP0 by shunting W11-8 between pin 2 and pin 3. CSP0 is enabled from reset and should be used to test the application program properly.

? Insert RAM chip in socket U6B. Notice that U6A does not have address line 0 routed, and it is used for expanded wide mode. On the other hand, U6B does have address line 0 routed directly and is designed for the use of expanded narrow mode.

? When memory paging is enabled, the EVB includes the footprint for a 28- and 32-pin RAM footprint. Address lines 16 and 18 are hardwired to U6B. However, address line 17 needs to be configured via jumper header W12 by shunting pin 3 and pin 4.