MPI-925A中文資料BOSER數(shù)據(jù)手冊(cè)PDF規(guī)格書

FEATURES

* Input Voltage: 90~265VAC

* Input Frequency: 47~63Hz

* Inrush Current: Does not exceed 30A at 115VAC input or 60A AC input, at cold start 25°C

* Load Range: When all outputs are at 60 rated load condition, the +5V output is set between 4.90~5.10V and all other outputs are within the specified voltage accuracy range

* Ripple And Noise: Peak to peak ripple and noise for each output is < 1 of each output voltage at rated load 115~230VAC

* Line Regulation: < +/-1 at rated load with +/-10 change in input voltage

* Load Regulation: The output voltage load regulation is less than the values on the table when each output loading changes +/-40 from 60 rated load while all other outputs at 60 rated load

* Hold Up Time: 14ms typ. from the last AC line charging pulse to the point when +5V drops down to +4.75V

* Output Power: Total DC continuous power is within 200W at 40oC ambient temperature. If the input voltage is < 100VAC, total DC continuous power should not exceed 180W

* Power Good Signal: Goes high 100~500ms after all DC output is ready

* Power Failure: Goes low 1ms before any DC output falls

* Efficiency: > 65 at nominal line and rated load

* Altitude: 10,000 feet

* Protection: Built-in crowbar circuit automatically shuts down outputs to avoid damaging external circuits. Trip point of O.V.P. circuit is between 5.7~7.0V

* Temperature: 0~+70°C (operating); -40~+75°C (storage)

* Humidity: 5~95; non-condensing at 40oC (operating)

* Connectors:

AC Input/Output: Meets IEC 320/CEE 22 standard

Tab Terminals: Female 0.250 x 0.032

CPU Board: Alex 8500-06 or equivalent device 3.5 Disk Drive: AMP 1-480424-0/171822-4 or equivalent device

* Dimensions: 14.0 x 15.0 x 8.62 cm with +/-0.8mm and +/- 0.4mm tolerance between mounting holes

* MTBF: 156,598 hrs.