NCA9539中文資料安世數(shù)據(jù)手冊PDF規(guī)格書

General description

The NCA9539 provides 16 bits of General Purpose Input/Output (GPIO) expansion with interrupt

and reset for I2C-bus/SMBus applications. It is designed for a wide voltage range of 1.65 V to

5.5 V. Nexperia GPIO expanders provide an elegant solution when additional IOs are needed while

keeping the interconnections to a minimum, for example, in ACPI power switches, sensors, push

buttons, LEDs and fan control. The NCA9539 contains a set of 8 bit input, output, configuration

and polarity inversion registers. At power up all IOs default to inputs. Each IO can be configured as

either input or output by changing the corresponding bit in the configuration register. The data for

each input or output is stored in the corresponding input or output register. The polarity inversion

register can be programmed to invert the polarity of the read register. The NCA9539 has an opendrain

interrupt output which is activated when any one of the GPIO changes from its corresponding

input port register state. INT can be connected to the interrupt input of a microcontroller. By

sending an interrupt signal on this line, the remote I/O can inform the microcontroller if there is

incoming data on its ports without having to communicate via the I2C-bus. Thus, NCA9539 can

remain a simple slave. The power on reset sets the registers to default values and initializes the

device state machine. The RESET pin can be used to achieve same reset functionality without

power down/up cycling by keeping active low. The state machine and the registers are in their

default state until the RESET input is once again HIGH. This input requires pull up to VCC. The

NCA9539 has two address pins A0 and A1 which can be used to configure the I2C bus slave

address of the device. It allows up-to four devices to share the same I2C-bus/SMBus.

Features and benefits

? I2C-bus to parallel port expander

? Operating power supply voltage range of 1.65 V to 5.5 V

? Low standby current consumption:

? 2.5 μA (maximum)

? Schmitt-trigger action allows slow input transition and better switching noise immunity at the

SCL and SDA inputs

? Vhys = 0.10 × VCC (typical)

? Noise filter on SCL and SDA inputs

? 5 V tolerant I/Os

? 16 I/O pins which power up configured in input state

? Open-drain active LOW interrupt output (INT)

? Reset input for resetting NCA9539 to default values (RESET)

? 400 kHz Fast-mode I2C-bus

? Internal power-on reset

? No glitch on power-up

? Latched outputs with 25 mA drive maximum capability for directly driving LEDs

? Latch-up performance exceeds 100 mA per JESD78, Class II

? ESD protection:

? HBM ANSI/ESDA/JEDEC JS-001 Class 2 exceeds 2000 V

? CDM ANSI/ESDA/JEDEC JS-002 Class C3 exceeds 1000 V

? Specified from -40 °C to +85 °C