PCA9420_V02中文資料恩智浦數據手冊PDF規(guī)格書

1 General description

The PCA9420 is a highly integrated Power Management IC (PMIC), targeted to provide a full power

management solution for low-power microcontroller applications or other similar applications.

The device consists of a linear battery charger capable of charging up to 315 mA current. It has an I2C programmable Constant Current (CC) and Constant Voltage (CV) values for flexible configuration. Various builtin protection features such as input overvoltage protection, overcurrent protection, thermal protection, etc. are also provided for safe battery charging. It also features JEITA-compliant charging. The device also integrates two step-down (buck) DC-DC converters which have I2C programmable output voltage. Both buck regulators have integrated high-side and low-side switches and related control circuitry, to minimize the external component counts; a Pulse-Frequency Modulation (PFM) approach is utilized to achieve better efficiency under light load condition. Other protection features such as overcurrent protection, undervoltage

lockout (UVLO), etc., are also provided. By default, the input for these regulators is powered by either VIN or VBAT, whichever is greater. In addition, two on-chip LDO regulators are provided to power up various voltage rails in the system. Other features such as Fm+ I2C-bus interface, chip enable, interrupt signal, etc. are also provided. The chip is offered in 2.09 mm x 2.09 mm, 5 x 5 bump, 0.4 mm pitch WLCSP package; and 3 mm x 3 mm, 24-pin QFN package.

2 Features and benefits

? Linear battery charger for charging single cell li-ion battery

– 20 V tolerance on VIN pin

– Programmable input OVP (5.5 V or 6 V)

– Programmable constant current (up to 315 mA) and pre-charge low voltage current threshold

– Programmable constant voltage regulation

– Programmable automatic recharge voltage and termination current threshold

– Built-in protection features such as input OVP, battery SCP, thermal protection

– JEITA compliant

– Battery attached detection

– Over-temperature protection

? Two step-down DC-DC converters

– Very low quiescent current

– Programmable output voltage

– SW1: core buck converter, 0.5 V to 1.5 V output, 25 mV/step, and a fixed 1.8 V, up to 250 mA

– SW2: system buck converter, 1.5 V to 2.1 V/2.7 V to 3.3 V output, 25 mV/step, up to 500 mA

– Low-power mode for extra power saving

? Two LDOs

– Programmable output voltage regulation

– LDO1: always-on LDO, 1.70 V to 1.90 V output, 25 mV/step, up to 1 mA

– LDO2: system LDO, 1.5 V to 2.1 V/2.7 V to 3.3 V output, 25 mV/step, up to 250 mA

? 1 MHz I2C-bus target interface

? -40 °C to +85 °C ambient temperature range

? Offered in 5 x 5 bump-array WLCSP and 24-pin QFN package

3 Applications

? Low power microcontroller application