PEB20525中文資料英飛凌數(shù)據(jù)手冊PDF規(guī)格書

Introduction

The SEROCCO-H is a Serial Communication Controller with two independent serial channels1). The serial channels are derived from updated protocol logic of the ESCC and DSCC4 device family providing a large set of protocol support and variety in serial interface configuration. This allows easy integration to different environments and applications.

Features

Serial communication controllers (SCCs)

? Two independent channels

? Full duplex data rates on each channel of up to 12.5 Mbit/s sync - 2 Mbit/s with DPLL

? 64 Bytes deep receive FIFO per SCC

? 64 Bytes deep transmit FIFO per SCC

Serial Interface

? On-chip clock generation or external clock sources

? On-chip DPLLs for clock recovery

? Baud rate generator

? Clock gating signals

? Clock gapping capability

? Programmable time-slot capability for connection to TDM interfaces (e.g. T1, E1)

? NRZ, NRZI, FM and Manchester data encoding

? Optional data flow control using modem control lines (RTS, CTS, CD)

? Support of bus configuration by collision detection and resolution

Bit Processor Functions

? HDLC/SDLC Protocol Modes

– Automatic flag detection and transmission

– Shared opening and closing flag

– Generation of interframe-time fill ’1’s or flags

– Detection of receive line status

– Zero bit insertion and deletion

– CRC generation and checking (CRC-CCITT or CRC-32)

– Transparent CRC option per channel and/or per frame

– Programmable Preamble (8 bit) with selectable repetition rate

– Error detection (abort, long frame, CRC error, short frames)

? Bit Synchronous PPP Mode

– Bit oriented transmission of HDLC frame (flag, data, CRC, flag)

– Zero bit insertion/deletion

– 15 consecutive ’1’ bits abort sequence

? Octet Synchronous PPP Mode

– Octet oriented transmission of HDLC frame (flag, data, CRC, flag)

– Programmable character map of 32 hard-wired characters (00H-1FH)

– Four programmable characters for additional mapping

– Insertion/deletion of control-escape character (7DH) for mapped characters

? Extended Transparent Mode

– Fully bit transparent (no framing, no bit manipulation)

– Octet-aligned transmission and reception

? Protocol and Mode Independent

– Data bit inversion

– Data overflow and underrun detection

– Timer

(Continue ...)