1 Features

? 1.6V to 5.5V input voltage range

– Device input voltage > 1.65V for start-up

? 1V to 5.5V output voltage range(adjustable)

? High output current capability, 3A peak switch

current

– 1.5A output current for VIN ≥ 3V, VOUT = 3.3V

– 1.2A output current for VIN ≥ 2.7V, VOUT = 3.3V

? High efficiency over the entire load range

– 8μA typical quiescent current

– Automatic power save mode and forced PWM

mode configurable

? Peak current buck-boost mode architecture

– Seamless mode transition

– Forward and reverse current operation

– Start-up into pre-biased outputs

– Fixed-frequency operation with 2MHz switching

? Safety and robust operation features

– Overcurrent protection and short-circuit

protection

– Integrated soft start with active ramp adoption

– Overtemperature protection and overvoltage

protection

– True shutdown function with load disconnect

– Forward and backward current limit

? Small solution size

– 2.6mm × 2.0mm × 1.2mm(max) 8-pin μSiP

package

2 Applications

? TWS

? System pre-regulator (smartphone, tablet,

terminal, telematics)

? Point-of-load regulation (wired sensor, port/cable

adapter, and dongle)

? Fingerprint, camera sensors (electronic smart lock,

IP network camera)

? Voltage stabilizer (datacom, optical modules,

cooling/heating)

3 Description

The TPSM83102 and TPSM83103 are constant

frequency peak current mode control buck-boost

converters in samll μSiP module package. It has a

3A peak current limit (typical) and 1.6V to 5.5V input

voltage range, and provide a power supply solution for

system pre-regulators and voltage stabilizers.

Depending on the input voltage, the TPSM83102 and

TPSM83103 automatically operate in boost, buck, or

in 3-cycle buck-boost mode when the input voltage

is approximately equal to the output voltage. The

transitions between modes happen at a defined

duty cycle and avoid unwanted toggling within the

modes to reduce output voltage ripple. 8-μA quiescent

current and power save mode power enable the

highest efficiency for light to no-load conditions.

The device offers a very small solution size in μSiP

module package.