TXS0104ENMNR集成電路（IC）的轉換器電平移位器規(guī)格書PDF中文資料

TXS0104ENMNR屬于集成電路（IC）的轉換器電平移位器。由德州儀器制造生產的TXS0104ENMNR轉換器，電平移位器邏輯轉換器或電平移位器 IC 可用于在數(shù)字邏輯設備之間傳遞信息，這些設備可在不同/不兼容的供電電壓下工作，或可實現(xiàn)不同的信令方式。例如，可以將需要 5 V 電源的數(shù)字輸出傳感器連接到具有 3.3 V I/O 電源的 FPGA，或者在 CMOS 或 TTL 等單端信令方式與 PECL 或 LVDS 等差分技術之間進行轉換。

1 Features

? No direction-control signal needed

? Maximum data rates:

– 24Mbps (push pull)

– 2Mbps (open drain)

? Available in the Texas Instruments NanoFree?

package

? 1.65 V to 3.6 V on A port and 2.3 V to 5.5 V on B

port (VCCA ≤ VCCB)

? No power-supply sequencing required – VCCA or

VCCB can be ramped first

? Latch-up performance exceeds 100 mA per JESD

78, class II

? ESD protection exceeds JESD 22:

– A port:

? 2000-V Human-Body Model (A114-B)

? 200-V Machine Model (A115-A)

? 1000-V Charged-Device Model (C101)

– B port:

? 15-kV Human-Body Model (A114-B)

? 200-V Machine Model (A115-A)

? 1000-V Charged-Device Model (C101)

? IEC 61000-4-2 ESD (B port):

– ±8-kV contact discharge

– ±10-kV air-gap discharge

2 Applications

? Handset

? Smartphone

? Tablet

? Desktop PC

3 Description

This 4-bit non-inverting translator uses two separate

configurable power-supply rails. The A port is

designed to track VCCA. VCCA accepts any supply

voltage from 1.65 V to 3.6 V. VCCA must be less

than or equal to VCCB. The B port is designed to

track VCCB. VCCB accepts any supply voltage from 2.3

V to 5.5 V. This allows for low-voltage bidirectional

translation between any of the 1.8-V, 2.5-V, 3.3-V, and

5-V voltage nodes.

When the output-enable (OE) input is low, all outputs

are placed in the high-impedance state.

The TXS0104E is designed so that the OE input

circuit is supplied by VCCA.

For the high-impedance state during power up

or power down, tie OE to GND through a pulldown

resistor; the minimum value of the resistor is

determined by the current-sourcing capability of the

driver.